特种绕组线规格.第36部分:180级自粘性直焊聚酯亚胺漆包铜圆线

[中文适用范围]： IEC 60317的本部分规定了180级双涂层可焊漆包圆铜绕组线的要求。底层涂层基于聚酯酰亚胺树脂@，只要保留原始树脂的化学特性并满足所有指定的电线要求，就可以对其进行修改。叠加涂层是基于热塑性树脂的粘合层。注：改性树脂是经过化学变化@或含有一种或多种添加剂以增强某些性能或应用特性的树脂。本部分涵盖的导体标称直径范围为： ?C 1B级：0@020 mm至1@600 mm； ?C 2B 级：0@020 mm 至 1@600 mm。 IEC 60317-0-1:2013 第 4 条规定了标称导体直径。 [外文原描述]： IEC 60317-36:2013 specifies the requirements of solderable enamelled round copper winding wire of class 180 with a dual coating. The underlying coating is based on polyesterimide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is a bonding layer based on a thermoplastic resin. NOTE - A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics. The range of nominal conductor diameters covered by this part is: - Grade 1B: 0,020 mm up to and including 1,600 mm; - Grade 2B: 0,020 mm up to and including 1,600 mm. The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-1:2013. This second edition cancels and replaces the first edition published in 1992, Amendment 1:1997 and Amendment 2:1999. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: - new 3.2.2 containing general notes on winding wire, formerly a part of the scope; - revision to references to IEC 60317-0-1:2013 to clarify that their application is normative; - consolidation of 17.1 and 17.2 of the solderability requirements; - new Clause 23, Pin hole test. Keywords: requirements of solderable enamelled round copper winding wire, class 180, dual coating