柔性绝缘套管第3部分:套管类型规格121至124:挤出硅胶套管

[中文适用范围]： IEC 60684-3 的下列文件规定了四种挤出硅胶弹性体非热缩套管的规范。这些套管通常提供内径高达 25 毫米，壁厚范围在 0.1 毫米至 2.0 毫米之间。国家标准可以选择内径和壁厚的优选组合的缩减列表。这些套管通常提供以下不透明颜色：黑色、棕色、红色、橙色、黄色、绿色、蓝色、紫色、灰色、白色和粉红色。它们也以半透明形式提供。除本规范中具体指出的尺寸和颜色外，其他尺寸和颜色可能作为特殊项目提供。如果这些项目满足表 2 中列出的其他特性要求，则应视为符合本规范。 These sheets of IEC 60684-3 gives the requirements for four types of non-heatshrinkable sleeving, extruded from silicone elastomer. These sleeves are normally available with internal diameter up to 25 mm and in a range of wall thicknesses between 0,1 mm and 2,0 mm. National standards may select a restricted list of preferred combinations of internal diameter and wall thickness. These sleeves are normally available in the following opaque colours: black, brown, red, orange, yellow, green, blue, violet, grey, white and pink. They are also available in a translucent form. Sizes or colours other than those specifically listed in this standard may be available as custom items. These items shall be considered to comply with this standard if they comply with the other property requirements listed in table 2. [外文原描述]： Gives the requirements for four types of non-heatshrinkable sleeving, extruded from silicone elastomer. These sleevings are normally available with internal diameter up to 25 mm and in a range of wall thicknesses between 0,1 mm and 2,0 mm. National standards may select a restricted list of preferred combinations of internal diameter and wall thickness.