柔性绝缘套管 - 第3部分:各种套管规格 - 板材403至405:带有丙烯酸涂层的玻璃纺织套管

[中文适用范围]： 本国际标准规定了三种类型的E型玻璃纤维编织或针织套管（带连续丙烯酸涂层）的要求，并根据其击穿电压进行区分：高介电强度（第403页）、中介电强度（第404页）和低介电强度（第405页）。这些套管适用于最高155°C的温度。套管通常提供内径在0.3毫米至25毫米之间、壁厚在0.15毫米至1.20毫米之间的规格。套管通常提供以下颜色：黑色、白色、红色、黄色、蓝色、棕色、绿色、绿/黄色和自然色。除本规范中列出的尺寸或颜色外，其他尺寸或颜色可作为特殊产品提供。如果这些产品符合表2和表4中列出的其他性能要求，则应视为符合本规范。符合本规范的材料满足既定的性能水平。然而，用户为特定应用选择材料时，应基于该应用所需的实际要求，而不仅仅基于本规范。 This International Standard gives the requirements for three types of E-type glass sleeving using either braided or knitted construction with a continuous acrylic based coating, and differentiated by their breakdown voltage: high breakdown voltage (sheet 403), medium breakdown voltage (sheet 404) and low breakdown voltage (sheet 405). These sleeves have been found suitable for use at temperatures up to 155°C. The sleeving is normally available with internal diameters between 0,3 mm and 25 mm and in wall thicknesses between 0,15 mm and 1,20 mm. The sleeving is normally supplied in the following colours: black, white, red, yellow, blue, brown, green, green/yellow and natural. Sizes or colours other than those specifically listed in this standard may be available as custom items. These items shall be considered to comply with this standard if they comply with the other property requirements listed in tables 2 and 4. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone. [外文原描述]： Gives the requirements for three types of E-type glass sleeving using either braided or knitted construction with a continuous acrylic based coating, and differentiated by their breakdown voltage: high breakdown voltage (sheet 403), medium breakdown voltage (sheet 404) and low breakdown voltage (sheet 405). These sleevings have been found suitable for use at temperatures up to 155 °C. Materials which conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.