标准摘要
[中文适用范围]： 本部分IEC 60730适用于自动控制油、气、煤或其他可燃物燃烧器的自动电气燃烧器控制系统，用于家庭及类似用途，包括供暖、空调及类似用途。 本部分2-5适用于完整的燃烧器控制系统、独立的编程单元、独立的电子高压点火源以及独立的火焰检测器。 本部分还适用于用于商店、办公室、医院、农场及商业和工业应用中的电气燃烧器控制系统，以及专门用于工业过程应用（如ISO TC 244覆盖的应用）的系统。 本部分适用于标称电压不超过660 V交流或600 V直流的系统，以及额定电流不超过63 A的系统。 本部分适用于使用NTC或PTC热敏电阻的系统。 本部分包括响应火焰特性和温度（HTO）的系统。 本部分不适用于热电火焰监督控制系统（由ISO 23551-6覆盖），也不适用于专门设计用于工业应用的系统（除非是特定过程应用）。 本部分不控制响应值依赖于控制设备在设备中安装方法的自动动作。若响应值对用户或周围环境保护至关重要，则适用相应设备标准中定义的数值或由制造商确定的数值。 [外文原描述]： IEC 60730-2-5:2013+A1:2017 applies to automatic electrical burner control systems for the automatic control of burners for oil, gas, coal or other combustibles for household and similar use including heating, air conditioning and similar use. This part 2-5 is applicable to a complete burner control system and to a separate programming unit. This part 2-5 is also applicable to a separate electronic high-voltage ignition source and to a separate flame detector. Separate ignition devices (electrodes, pilot burners, etc.) are not covered by this part 2-5 unless they are submitted as part of a burner control system. Requirements for separate ignition transformers are contained in IEC 60989. Systems utilizing thermoelectric flame supervision are not covered by this part 2-5. This part 2-5 applies to the inherent safety, to the manufacturer's declared operating values, operating times and operating sequences where such are associated with burner safety and to the testing of automatic electrical burner control systems used in, on, or in association with, burners. It was established on the basis of the fourth edition (2010) of that publication. Consideration may be given to future editions of, or amendments to, IEC 60730-1. The title of IEC 60730-2-5 Ed4.0 has been updated to the title of IEC 60730-1 Ed5.0. However, IEC 60730-2-5 Ed4.0 has not been updated in accordance with the technical requirements in IEC 60730-1 Ed5.0. This part 2-5 supplements or modifies the corresponding clauses in IEC 60730-1 so as to convert that publication into the IEC standard: Safety requirements for automatic electrical burner control systems. This consolidated version consists of the first edition (2013) and its amendment 1 (2017). Therefore, no need to order amendment in addition to this publication. This publication is to be read in conjunction with IEC 60730-1:2013 . The contents of the corrigendum of October 2023 have been included in this copy. Key words: automatic control, burner control
英文名称Automatic electrical controls - Part 2-5: Particular requirements for automatic electrical burner control systems