标准摘要
[中文适用范围]： IEC 61347 的这一部分规定了在 50 Hz 或 60 Hz 时电压高达 250 V 的直流电源和/或电压高达 1000 V 的交流电源上使用的灯控制设备的一般和安全要求。该标准还涵盖尚未标准化的灯的灯控制装置。本标准涉及的试验为型式试验。不包括在生产过程中测试单个灯控制装置的要求。 IEC 60598-1 中给出了半灯具的要求（参见定义 1.2.60）。除了 IEC 61347 第 1 部分中给出的要求外，附录 B 还规定了适用于热保护灯控制设备的一般和安全要求。附件 C 规定了附加的一般和安全要求，因为它们适用于具有过热保护装置的电子灯控制装置。附录 I 给出了具有双重或加强绝缘的内置镇流器的附加要求。 [外文原描述]： This part of IEC 61347 specifies general and safety requirements for lamp controlgear for use on d.c. supplies up to 250 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. This second edition cancels and replaces the first edition published in 2000 and its Amendment 1 (2003). It constitutes a technical revision. The definition clause has been extended (rated no-load output voltage, controllable ballasts, control terminals, control signal). General requirements for lamp control gear which do not have their own enclosure have been added. The informative information (for ballasts in lamp standards) is now transformed into a normative requirement (in ballast standards). The test schedule has been minimised where possible, see 5.7 and Annex J. For printed circuit boards, the (non-) inflammability requirements have been specified. An Annex on conformity testing during manufacture has been added.
英文名称Lamp controlgear - Part 1: General and safety requirements