电光源控制装置 安全 第2-13部分：特殊要求 LED 光源电子控制装置

[中文适用范围]： 本部分 IEC 61347 规定了用于 LED 光源的电子控制装置的安全要求，适用于直流电源电压不超过 1500 V 或交流电源电压不超过 1000 V（50 Hz 或 60 Hz）的情况。 本文件适用于输出电压（有效值）不超过 1000 V 的 LED 光源电子控制装置。 注 1：控制单元，如连接在电源单元和 LED 光源之间用于控制或调节 LED 光源运行的设备，也适用于本文件。 注 2：性能要求见 IEC 62384。 注 3：此类控制装置也可用于产生光学辐射的电源，其技术相同但用途不同于照明，且产生的辐射不在可见光谱范围内。 [外文原描述]： IEC 61347-2-13:2024 specifies safety requirements for electronic controlgear for LED light sources for use on DC supplies up to 1 500 V or on AC supplies up to 1 000 V at 50 Hz or 60 Hz. This document is applicable for electronic controlgear for LED light sources with an output voltage (RMS) not higher than 1 000 V. This third edition cancels and replaces the second edition published in 2014 and Amendment 1:2016. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) alignment with respect to the fourth edition of IEC 61347-1: - introduction of dated references to the fourth edition of IEC 61347-1 as appropriate; - deletion of the clauses and subclauses which are either no longer relevant or now covered in IEC 61347-1; b) update of normative references, introducing dated references where appropriate; c) scope extension to 1 500 V for direct current; d) scope clarification; e) deletion of unused definitions; f) revision of information and marking requirements; g) new marking requirement "electronic controlgear for LED light sources"; h) new requirements for electronic controlgear for LED light sources with constant light output function or programmable current (additions to Clause 3, Clause 6, Clause 16 and Clause 18); i) modification of requirements for the determination of the output working voltage (new Clause 17); j) new requirements for the determination of the rated output characteristics (Clause 18).