光纤互连器件和无源元件 - 可靠性 - 第9-1部分:无源光学元件的认证

[中文适用范围]： 本部分IEC 62005建立了一套通用的可靠性资格认证计划，适用于除连接器和连接器组件外的所有无源光纤组件，通过认证表明达到了最低水平的可靠性保证，并允许将该特定设备称为符合本标准要求的认证产品。 本国际标准的 objectives 如下： – 规定无源光学组件通用可靠性资格标准（RQS）的要求； – 为供应商和最终用户提供关于生产和采购无源光学组件的指导意见，以满足和验证特定服务环境下的可靠性资格标准； – 提供可靠性资格应力测试项目清单及条件的最低要求； – 建立选择适当测量方法和通过/失败标准的指导原则； – 提供相关参考资料；以及 – 建立最低报告要求。 本标准定义了一系列应力测试、其严重程度、序列、测试设备数量（DUT）、接受标准及报告要求。还提供了选择适当测量方法和通过/失败标准的指导原则。 [外文原描述]： IEC 62005-9-1:2015 establishes a general reliability qualification program that applies to all passive fibre optic components except connectors and connector assemblies, the passing of which, suggests a minimum level of reliability assurance and allows that specific device to be called qualified to this standard. The objectives of this International Standard are as follows: - to specify the requirements for a general reliability qualification standard (RQS) for passive optical components; - to give direction to the supplier and to the end user on the production and purchase of passive optical components to meet and verify reliability qualification standards for certain specified service environments; - to give the minimum list of reliability qualification stress tests and conditions; - to establish guidance for the selection of appropriate measurements and pass/fail criteria; - to give relevant references; - and to establish the minimum reporting requirements. This standard defines a series of stress tests, their severity, sequences, quantities of devices under the test (DUT), acceptance criteria, and reporting requirements. It also gives guidelines to selecting appropriate measurements and pass/fail criteria. Keywords: reliability qualification standard (RQS) for passive optical components