光伏组件.运输试验.第1部分:组件组件的运输和装运

[中文适用范围]： Photovoltaic (PV) modules are electrical devices intended for continuous outdoor exposure during their lifetime. Existing type approval standards do not consider mechanical stresses that may occur during transportation to the PV installation destination. This part of IEC 62759 describes methods for the simulation of transportation of complete package units of modules and combined subsequent environmental impacts. A list of design modifications which require a retest is provided in Annex B. This document applies to flat plate photovoltaic modules. Les modules photovoltaïques (PV - photovoltaic) sont des dispositifs électriques destinés à une exposition extérieure continue pendant leur durée de vie. Les normes d'homologation existantes ne prennent pas en considération les contraintes mécaniques pouvant survenir au cours du transport vers la destination d'installation du PV. La présente partie de l'IEC 62759 décrit les méthodes de simulation de transport de l'ensemble des unités d'emballage des modules et des impacts environnementaux résultats combinés. L'Annexe B fournit une liste des modifications de la conception qui exige un contre-essai. Le présent document s'applique aux modules photovoltaïques à plaque plane. [外文原描述]： IEC 62759-1:2022 CMV contains both the official standard and its commented version. The commented version provides you with a quick and easy way to compare all the changes between IEC 62759-1:2022 edition 2.0 and the previous IEC 62759-1:2015 edition 1.0. Furthermore, comments from IEC TC 82 experts are provided to explain the reasons of the most relevant changes, or to clarify any part of the content. IEC 62759-1:2022 describes methods for the simulation of transportation of complete package units of modules and combined subsequent environmental impacts. This second edition cancels and replaces the first edition published in 2015. This edition includes the following significant technical changes with respect to the previous edition: a. Cancellation of tests and references to relevant standards for CPV. b. Deletion of different classes for PV modules. c. Deletion of requirement for minimum 10 modules per shipping unit. d. Implementation of stabilization as intermediate measurement. e. Addition of pass/fail criteria. f. Change of requirements for retesting. g. Change of number of cycles in dynamic mechanical load test.