+AMD1:2025 CSV 电动手持工具、便携式工具及园林机械 - 安全性 第2-8部分：手动剪切机和咬合机的特殊要求

[中文适用范围]： IEC 62841-2-8:2016+AMD1:2025 CSV 适用于手持式剪钳和剪断机，单相交流或直流工具的额定电压不超过 250 V，三相交流工具的额定电压不超过 480 V。额定输入不超过 3 700 W。本标准对电池工具的适用性限制在 K.1 和 L.1 中给出。本标准涉及工具带来的危险，所有人在正常使用和合理可预见的误用工具时都会遇到这些危险。手持式电动工具属于本标准的范围，此类工具可安装在支架或工作台上用作固定工具，而无需对工具本身进行任何改动，而手持式工具和支架的这种组合被视为可移动式工具，因此包含在相关的第 3 部分中。请国家委员会注意，在新的、修订的或修订的 IEC 出版物发布后，设备制造商和测试组织可能需要一个过渡期，以便根据新要求生产产品并装备自己进行新的或修订的测试。委员会建议，本出版物的内容应在发布之日起 36 个月内在全国范围内实施。关键词：剪切机、冲剪机、手持式工具、可移动式工具本出版物应与 IEC 62841-1:2014 结合阅读。 [外文原描述]： IEC 62841-2-8:2016+AMD1:2025 CSV applies to hand-held shears and nibblers the rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V for three-phase a.c. tools. The rated input is not more than 3 700 W. The limits for the applicability of this standard for battery tools are given in K.1 and L.1. This standard deals with the hazards presented by tools which are encountered by all persons in the normal use and reasonably foreseeable misuse of the tools. Hand-held electric tools, which can be mounted on a support or working stand for use as fixed tools without any alteration of the tool itself, are within the scope of this standard and such combination of a hand-held tool and a support is considered to be a transportable tool and thus covered by the relevant Part 3. The attention of National Committees is drawn to the fact that equipment manufacturers and testing organizations may need a transitional period following publication of a new, amended or revised IEC publication in which to make products in accordance with the new requirements and to equip themselves for conducting new or revised tests. It is the recommendation of the committee that the content of this publication be adopted for implementation nationally not earlier than 36 months from the date of publication. Keywords: Shear, Nibbler, Hand-held tool, Transportable tool This publication is to be read in conjunction with IEC 62841-1:2014 .