标准摘要
[中文适用范围]： 本文件规定了用于抗电阻点焊和压痕对接接头剥落测试的操作程序和推荐工装。该文件适用于两张或更多张厚度在0.5毫米至3.0毫米范围内的板件之间的焊缝。这些试验的目的是：通过破坏性测试确定焊缝尺寸和断裂模式；- 非破坏性凿测试验证焊缝。 NOTE 对于对接接头的撕剥测试（机械化撕剥测试）的方法在IS0 14270中所述。 [外文原描述]： This document specifies the procedures and recommended tooling to be used for peel and chisel testing of resistance spot and embossed projection welds. This document applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm. The aim of these tests is to determine: — weld size and failure mode when welds are destructively tested; — verification of welds by non-destructive chisel tests. NOTE The preferred method of peel testing seam welds (mechanized peel testing) is covered in ISO 14270 .
英文名称Resistance welding — Testing of welds — Peel and chisel testing of resistance spot and projection welds