标准摘要
[中文适用范围]： 本文件规定了推力环和可倾瓦推力轴承表面通过润滑剂膜完全分离的油润滑流体动压滑动轴承的计算方法。 本文件适用于带有倾斜式滑块（可倾瓦）的滑动推力轴承，在运行过程中会自动形成楔形润滑间隙。 一个瓦块的宽度与长度之比可以在 B/L = 0.5 到 2 的范围内变化。 本文件不适用于重载可倾瓦推力轴承。 注：存在等效的计算程序，可以估计操作条件并根据可接受的条件进行检查。 使用它们同样是允许的。 [外文原描述]： This document specifies a calculation method for oil-lubricated hydrodynamic plain bearings with complete separation of the thrust collar and tilting pad thrust bearing surfaces by a film of lubricant. This document applies to plain thrust bearings with tilting-type sliding blocks (tilting pads), where a wedge-shaped lubrication clearance gap is automatically formed during operation. The ratio of width to length of one pad can be varied in the range B/L = 0,5 to 2. This document is not applicable to heavily loaded tilting pad thrust bearings. NOTE Equivalent calculation procedures exist that enable operating conditions to be estimated and checked against acceptable conditions. The use of them is equally admissible.
英文名称Plain bearings — Hydrodynamic plain tilting pad thrust bearings under steady-state conditions — Part 1: Calculation of tilting pad thrust bearings