标准摘要
[中文适用范围]： ISO 16063 的这一部分规定了使用倒易法和 SI 单位制对加速度计进行初级校准的仪器和程序。 它适用于频率范围为 40 Hz 至 5 kHz、频率相关幅度范围为 10m/s 至 100 m/s 的直线加速度计的校准，并且基于使用电动振动器的线圈作为校准器。 互易换能器。 如果在校准过程中与传感器一起使用的信号调节器或放大器已被充分表征，则可以使用 ISO 16063 的这一部分来校准传感器的灵敏度。 为了实现第 3 条中给出的测量不确定度，假设传感器已与其信号调节器或放大器（其组合在 ISO 16063 的本部分中称为“加速度计”）一起进行了校准。 ）。 [外文原描述]： This part of ISO 16063 specifies the instrumentation and procedures to be used for primary calibration of accelerometers using the reciprocity method and the SI system of units. It is applicable to the calibration of rectilinear accelerometers over a frequency range of 40 Hz to 5 kHz and a frequency-dependent amplitude range of 10 m/s 2 to 100 m/s 2 and is based on the use of the coil of an electrodynamic vibrator as the reciprocal transducer. Calibration of the sensitivity of a transducer can be obtained using this part of ISO 16063 provided that the signal conditioner or amplifier used with the transducer during calibration has been adequately characterized. In order to achieve these measurement uncertainties, it has been assumed that the transducer has been calibrated in combination with its signal conditioner or amplifier (the combination of which in this part of ISO 16063 is referred to as the accelerometer).
英文名称Methods for the calibration of vibration and shock transducers — Part 12: Primary vibration calibration by the reciprocity method