橡胶软管和软管组件 用于液压应用的钢丝或纺织物增强单压型 规格

[中文适用范围]： 本文件规定了名义尺寸从5到102的十类、四个等级和七种类型钢丝或纺织增强液压软管及其组件的要求。每一类对于所有尺寸均有单一的最大工作压力。这些软管和组件适用于以下流体：——根据ISO 6743-4定义的油基液压流体HH、HL、HM、HR和HV，在温度范围为40°C至+100°C时适用于AS、AC、BS和BC类型的软管，温度范围为40°C至+120°C时适用于CS、CC和DC类型的软管；——根据ISO 6743-4定义的水基流体HFC、HFAE、HFAS和HFB，适用于温度范围为40°C至+70°C的软管；——适用于温度范围为0°C至+70°C的水。本文件未规定连接端的要求，仅限于软管和软管组件的性能。软管组件的最大工作压力由组件中最低的最大工作压力决定。注：用户应与软管制造商协商，确定软管与所用流体的相容性。 [外文原描述]： This document specifies requirements for ten classes, four grades and seven types of wire- or textile-reinforced hydraulic hoses and hose assemblies, of nominal sizes ranging from 5 to 102. Each class has a single maximum working pressure for all sizes. They are suitable for use with: — oil-based hydraulic fluids HH, HL, HM, HR and HV, as defined in ISO 6743-4, at temperatures ranging from −40 °C to +100 °C for types AS, AC, BS and BC hoses and from −40 °C to +120 °C for types CS, CC and DC hoses; — water-based fluids HFC, HFAE, HFAS and HFB, as defined in ISO 6743-4, at temperatures ranging from −40 °C to +70 °C; — water at temperatures ranging from 0 °C to +70 °C. This document does not specify requirements for the connection ends. It is limited to the performance of hoses and hose assemblies. The hose assembly maximum working pressure is governed by the lowest maximum working pressure of the components. NOTE It is the responsibility of the user, in consultation with the hose manufacturer, to establish the compatibility of the hose with the fluid to be used.