齿轮盘 - 精度要求

[中文适用范围]： 本文件规定了0.5模数至40模数通用滚刀的精度要求。 这些滚刀旨在生产符合 ISO 53 和 ISO 54 的齿轮。 本文件适用于正齿轮和斜齿轮的滚刀。 它适用于整体（整体）和插入式刀片滚刀。 滚刀的基本特性按精度分级如下： ——4A级； ——3A级； ——2A级； ——A级； ——B级； ——C级； ——D 级。 4A 级是最高级别的精度。 除了滚刀的基本测试之外，本文件还给出了沿作用线上的切削刃进行的复合测试的允许公差。 两组测试并不等同，可以选择其中一组。 如果没有事先约定，如果滚刀满足两种检验方法中的一种或另一种，则滚刀被视为属于规定的精度等级。 注：本文件中的公差是针对尺寸符合以下要求的齿轮滚刀确定的： [外文原描述]： This document specifies requirements for the accuracy of general-purpose hobs of 0,5 module to 40 module. These hobs are intended for producing gears which conform to ISO 53 and ISO 54. This document applies to hobs for spur and helical gears. It applies to solid (monobloc) and inserted blade hobs. The elemental features of hobs are graded according to accuracy, as follows: — Grade 4A; — Grade 3A; — Grade 2A; — Grade A; — Grade B; — Grade C; — Grade D. Grade 4A is the highest order of precision. In addition to the elemental tests for hobs, this document gives permitted tolerances for composite tests that are taken along the cutting edges on the line of action. The two groups of tests are not equivalent and one can choose between one or the other. If there was no previous agreement, the hob is regarded as belonging to the precision class specified if it satisfies one or the other of the two methods of inspection. NOTE The tolerances in this document were determined for gear hobs whose dimensions conform to ISO 2490, but with certain precautions they can be applied to hobs not specified in this document.